This Brembo performance brake kit is an exact-part-number brake component for the verified 1999-2008 Porsche 911 Carrera application listed below. Match manufacturer part number KT00B03, front or rear position, factory brake package, rotor and caliper configuration, wheel clearance, and every application note before ordering.

Key Features

• Prime Ceramic Brake Pads: NAO compound delivers quiet operation, minimal dust on rims, strong initial bite, and better wear resistance than semi-metallic pads.
• Complete Ready-to-Install Kit: Includes rotors, pads, retaining screws, hardware clips, wear indicators, lubricant, and anti-squeal shims for one-box rear brake service.
• Direct OE Replacement Fit: Bolts on to stock calipers on 1999-2008 Porsche 911 rear axles with no modifications needed.
• Vented Cross-Drilled Rotors with UV Coating: High-carbon cast iron construction ensures thermal stability and rust prevention while cross-drilling improves heat dissipation for shorter stops.
• High-carbon rotors and NAO pads deliver consistent performance and longevity.
• Rotors are vented and cross-drilled with UV coating to resist rust. pads are Prime Ceramic NAO for low dust and noise.

Fitment

Specifications

What’s Included

One new Brembo product identified by manufacturer part number KT00B03. Rotors, pads, calipers, brackets, lines, sensors, hardware, fluid, tools, and companion service parts are included only when expressly stated for this exact part number.

About Brembo

Brembo develops original-equipment replacement and performance braking components, including rotors, pads, calipers, brake kits, fluid, sensors, and related hardware. Correct selection remains exact-application and exact-part-number specific.

Related Brembo Products

• Brembo OE 01-05 Porsche 911 Rear Disc Brake Kit
• Brembo OE 01-05 Porsche 911 Rear Disc Brake Kit
• Brembo OE 05-12 Porsche 911 Rear Disc Brake Kit

Browse the Brembo collection for related brake components.

Frequently Asked Questions

Will this Brembo part fit my 1999-2008 Porsche 911 Carrera?
That application is listed, but confirm the front or rear position, factory brake package, rotor diameter and design, caliper type, wheel clearance, production split, and every Brembo application note before ordering.

Should brake components be replaced in axle pairs?
Friction parts are normally serviced in axle sets to maintain balanced braking. Follow the vehicle service procedure and inspect the opposite side, calipers, hoses, hardware, wheel bearings, and brake fluid before installation.

What should be checked before installing this Brembo part?
Compare every component and part number, verify wheel and caliper clearance, inspect mounting and sealing surfaces, measure rotor and hub runout when applicable, use specified torque values, bleed the system correctly, and follow the required bedding procedure.

Installation Instructions

Follow the current Brembo instructions and factory service information for this exact part number. Support the vehicle safely, compare all parts before removal, clean and inspect mounting surfaces, verify runout and wheel clearance, replace one-time hardware and seals as required, use specified torque values, bleed with the correct fluid, check for leaks and free wheel rotation, complete the required bedding procedure, and recheck operation before road use. Professional brake installation is strongly recommended.