The COBB Accessport V3 Grey Faceplate is a universal accessory or exact-interface component selected by manufacturer part number AP3-GREY-FACEPLATE and its stated size, thread, connector, mounting, software, or service requirements. Confirm every specification before ordering.

Key Features

• One-piece molded plastic construction with scratch resistant and weather resistant finish.

Fitment

Specifications

What’s Included

One new COBB product in the exact configuration and quantity identified by manufacturer part number AP3-GREY-FACEPLATE. Calibrations, hardware, hoses, clamps, gaskets, adapters, wiring, fluids, tools, and companion components are included only when expressly stated for this exact part number.

About COBB

COBB develops engine-management, intake, cooling, exhaust, drivetrain, suspension, and vehicle-accessory products for supported performance platforms. Correct selection remains exact-vehicle, exact-configuration, exact-interface, and exact-part-number specific.

Related COBB Products

• Cobb Accessport V3 Black Faceplate
• Cobb AccessPORT V3 OBDII Universal Cable
• Cobb Accessport V3 Zippercase

Browse the COBB collection for related tuning, intake, cooling, exhaust, drivetrain, and chassis products.

Frequently Asked Questions

How do I confirm this universal COBB product is correct?
Match the exact manufacturer part number, size, thread, connector, mounting, software or service requirement, quantity, and included components.

Are all supporting parts included?
Only components expressly listed for the exact manufacturer part number are included. Tuning, hardware, hoses, clamps, gaskets, adapters, wiring, fluids, and companion components may be separate.

Is tuning or calibration required after installation?
Requirements depend on the exact product and vehicle. Intake, fuel, boost, turbo, and engine-management changes may require a compatible calibration before operation.

Installation Instructions

Follow the current COBB and factory service instructions for this exact part number. Verify fitment, factory equipment, emissions eligibility, required calibration, software and firmware, interfaces, hardware, fluid or electrical connections, and clearances before installation. Inspect the completed work and confirm safe operation before full-load use.