Give Your Vehicle a Factory Inspired Custom Detail

The Rebadge Design & Graphics Carbon Fiber Trackhawk Supercharger Badge, part number RBDCBTSB, adds a clean custom detail with a vehicle focused design. Colors Our “Carbon Fiber Trackhawk Supercharger” badge features genuine carbon fiber and silver accents.

Fitment

Confirm that RBDCBTSB matches the year, make, model, and trim listed below before installation.

Specifications

What’s Included

• One selected Carbon Fiber Trackhawk Supercharger Badge
• Application ready mounting components when supplied by the manufacturer

About Rebadge Design & Graphics

Rebadge Design & Graphics develops custom automotive badges, inlays, and appearance components for enthusiasts who want a distinctive factory inspired finish.

Related Parts

• Carbon Fiber SRT Supercharger Badge
• Carbon Fiber SRT Trackhawk Steering Wheel Center Badge
• Carbon Fiber Trackhawk Fender Badge

FAQ

What is the RBDCBTSB?

This is the Rebadge Design & Graphics Carbon Fiber Trackhawk Supercharger Badge, a vehicle specific appearance upgrade for the applications listed in the fitment table.

Which vehicles are compatible?

This product fits only the year, make, model, and trim combinations shown in the fitment table. Compare the mounting location before installation.

Is this an OEM replacement part?

This is an aftermarket appearance component designed to customize the factory look.

How is this product installed?

Clean and dry the mounting surface, test the position, then install the component according to its supplied mounting method.

Does installation require special tools?

Most badge and inlay installations require only basic cleaning supplies and careful alignment. Mounting hardware products may require common hand tools.

Can this part be removed later?

Removal is generally possible with controlled heat and appropriate trim tools. Take care to protect the original surface.

Should the surface be prepared first?

Yes. Remove wax, grease, dust, and moisture before installation so the mounting surface is clean and dry.

Where should I verify fitment?

Use the fitment table on this page and compare the original mounting area on the vehicle before installation.

Install Instructions

1. Verify the product and application against the fitment and specifications on this page.
2. Clean the mounting area and remove wax, grease, dust, and moisture.
3. Test fit the component and confirm the final position before securing part number RBDCBTSB.
4. Install using the supplied or intended adhesive or mounting hardware.
5. Apply even pressure, confirm alignment, and allow adhesive to bond before exposing the area to moisture.