Give Your Vehicle a Factory Inspired Custom Detail

The Rebadge Design & Graphics Carbon Fiber T/H Start Button, part number RBDCFT/HSB, adds a clean custom detail with a vehicle focused design. Upgrade your Jeep Grand Cherokee Trackhawk with the ‘Carbon Fiber T/H’ Start Button , crafted from genuine carbon fiber for a sleek, high-performance look.

Fitment

Confirm that RBDCFT/HSB matches the year, make, model, and trim listed below before installation.

Specifications

What’s Included

• One selected Carbon Fiber T/H Start Button
• Application ready mounting components when supplied by the manufacturer

About Rebadge Design & Graphics

Rebadge Design & Graphics develops custom automotive badges, inlays, and appearance components for enthusiasts who want a distinctive factory inspired finish.

Related Parts

• Carbon Fiber Trackhawk Start Button
• T/H Start Button
• Trackhawk Start Button

FAQ

What is the RBDCFT/HSB?

This is the Rebadge Design & Graphics Carbon Fiber T/H Start Button, a vehicle specific appearance upgrade for the applications listed in the fitment table.

Which vehicles are compatible?

This product fits only the year, make, model, and trim combinations shown in the fitment table. Compare the mounting location before installation.

Is this an OEM replacement part?

This is an aftermarket appearance component designed to customize the factory look.

How is this product installed?

Clean and dry the mounting surface, test the position, then install the component according to its supplied mounting method.

Does installation require special tools?

Most badge and inlay installations require only basic cleaning supplies and careful alignment. Mounting hardware products may require common hand tools.

Can this part be removed later?

Removal is generally possible with controlled heat and appropriate trim tools. Take care to protect the original surface.

Should the surface be prepared first?

Yes. Remove wax, grease, dust, and moisture before installation so the mounting surface is clean and dry.

Where should I verify fitment?

Use the fitment table on this page and compare the original mounting area on the vehicle before installation.

Install Instructions

1. Verify the product and application against the fitment and specifications on this page.
2. Clean the mounting area and remove wax, grease, dust, and moisture.
3. Test fit the component and confirm the final position before securing part number RBDCFT/HSB.
4. Install using the supplied or intended adhesive or mounting hardware.
5. Apply even pressure, confirm alignment, and allow adhesive to bond before exposing the area to moisture.