This Brembo performance brake kit is an exact-part-number brake component for the verified 2016-2020 Mazda MX-5 Miata Club application listed below. Match manufacturer part number KT00905, front or rear position, factory brake package, rotor and caliper configuration, wheel clearance, and every application note before ordering.

Key Features

• Prime Ceramic Brake Pads: Minimize noise and vibration for driving comfort, with reduced friction wear, low dust emission, and clean wheels.
• High Carbon Cast Iron Discs: Provide higher damping coefficient to decrease vibration and noise, improve brake behavior, and enhance heat conduction for shorter cooling times.
• Xtra Disc Technology: Uses special alloy high-carbon materials tested for greater resistance to thermo-mechanical stress during hard braking.
• Complete Kit: Includes everything needed for rear brake replacement with no additional parts required.
• Rear Xtra discs measure 278 mm diameter x 20 mm thickness, made from high-carbon alloy for stress resistance.
• OE-Matched Materials: Brembo uses identical materials as original manufacturer for direct compatibility and consistent performance.

Fitment

Specifications

What’s Included

One new Brembo product identified by manufacturer part number KT00905. Rotors, pads, calipers, brackets, lines, sensors, hardware, fluid, tools, and companion service parts are included only when expressly stated for this exact part number.

About Brembo

Brembo develops original-equipment replacement and performance braking components, including rotors, pads, calipers, brake kits, fluid, sensors, and related hardware. Correct selection remains exact-application and exact-part-number specific.

Related Brembo Products

• Brembo OE 18-20 Mazda MX-5 Miata Front Disc Brake Kit
• Brembo OE 15-20 Audi A3 Quattro/19-23 Q3/15-20 S3/16-23 TTS Quattro/19-23 Arteon Rear Disc Brake Kit
• Brembo OE 15-20 Audi A3 Quattro/19-23 Q3/15-20 S3/16-23 TTS Quattro/19-23 Arteon Rear Disc Brake Kit

Browse the Brembo collection for related brake components.

Frequently Asked Questions

Will this Brembo part fit my 2016-2020 Mazda MX-5 Miata Club?
That application is listed, but confirm the front or rear position, factory brake package, rotor diameter and design, caliper type, wheel clearance, production split, and every Brembo application note before ordering.

Should brake components be replaced in axle pairs?
Friction parts are normally serviced in axle sets to maintain balanced braking. Follow the vehicle service procedure and inspect the opposite side, calipers, hoses, hardware, wheel bearings, and brake fluid before installation.

What should be checked before installing this Brembo part?
Compare every component and part number, verify wheel and caliper clearance, inspect mounting and sealing surfaces, measure rotor and hub runout when applicable, use specified torque values, bleed the system correctly, and follow the required bedding procedure.

Installation Instructions

Follow the current Brembo instructions and factory service information for this exact part number. Support the vehicle safely, compare all parts before removal, clean and inspect mounting surfaces, verify runout and wheel clearance, replace one-time hardware and seals as required, use specified torque values, bleed with the correct fluid, check for leaks and free wheel rotation, complete the required bedding procedure, and recheck operation before road use. Professional brake installation is strongly recommended.