This Brembo performance brake kit is an exact-part-number brake component for the verified 2000-2009 Honda S2000 application listed below. Match manufacturer part number KT00600, front or rear position, factory brake package, rotor and caliper configuration, wheel clearance, and every application note before ordering.

Key Features

• High Carbon Rotors: 09.B445.11 UV coated vented discs 300mm diameter offer better heat dissipation faster cooling and resistance to thermo-mechanical stress.
• Ceramic Brake Pads: P28032N Prime pads minimize noise vibration friction wear and dust for comfortable driving and clean rims.
• OEM-Quality Materials: Same high carbon cast iron as original equipment for consistent braking behavior and durability.
• Vented Design: Improves heat conduction and damping to decrease vibration noise and enhance overall brake feel.
• Complete Kit: Everything needed for front brake replacement including two rotors and one pad set for straightforward service.
• Bolt-on fit uses existing mounting points.

Fitment

Specifications

What’s Included

One new Brembo product identified by manufacturer part number KT00600. Rotors, pads, calipers, brackets, lines, sensors, hardware, fluid, tools, and companion service parts are included only when expressly stated for this exact part number.

About Brembo

Brembo develops original-equipment replacement and performance braking components, including rotors, pads, calipers, brake kits, fluid, sensors, and related hardware. Correct selection remains exact-application and exact-part-number specific.

Related Brembo Products

• Brembo OE 1998 Acura CL/00-02 Honda Accord Front Disc Brake Kit
• Brembo OE 01-07 Porsche 911/09-12 911 Front Disc Brake Kit
• Brembo OE 04-06 BMW 525i/06-07 525xi/04-07 530i/06-07 530xi/09-10 535i xDrive Front Disc Brake Kit

Browse the Brembo collection for related brake components.

Frequently Asked Questions

Will this Brembo part fit my 2000-2009 Honda S2000?
That application is listed, but confirm the front or rear position, factory brake package, rotor diameter and design, caliper type, wheel clearance, production split, and every Brembo application note before ordering.

Should brake components be replaced in axle pairs?
Friction parts are normally serviced in axle sets to maintain balanced braking. Follow the vehicle service procedure and inspect the opposite side, calipers, hoses, hardware, wheel bearings, and brake fluid before installation.

What should be checked before installing this Brembo part?
Compare every component and part number, verify wheel and caliper clearance, inspect mounting and sealing surfaces, measure rotor and hub runout when applicable, use specified torque values, bleed the system correctly, and follow the required bedding procedure.

Installation Instructions

Follow the current Brembo instructions and factory service information for this exact part number. Support the vehicle safely, compare all parts before removal, clean and inspect mounting surfaces, verify runout and wheel clearance, replace one-time hardware and seals as required, use specified torque values, bleed with the correct fluid, check for leaks and free wheel rotation, complete the required bedding procedure, and recheck operation before road use. Professional brake installation is strongly recommended.