DOT 4 Brake Fluid 1 L

Brembo L04010 is a 1 L container of DOT 4 brake fluid. Select the exact product for the installed brake system and verify all application requirements before ordering.

Key Features

• Manufacturer-listed fluid grade: DOT 4.
• Container volume: 1 L.
• Manufacturer dry ERBP minimum: 245 C.
• Manufacturer wet ERBP minimum: 157 C.
• Manufacturer part number: L04010.

Fitment

Before ordering L04010, confirm the exact brake configuration and every manufacturer application note. Existing vehicle references below are conditional and do not establish compatibility with every brake option.

Specification-based selection: use only where the vehicle manufacturer requires the fluid type and grade shown below.

Specifications

What’s Included

• One Brembo L04010 1 L container of DOT 4 brake fluid.

Service tools and bleeding equipment are separate. Use only where the vehicle manufacturer specifies this fluid type and grade.

About Brembo

Brembo manufactures braking components, service accessories and brake fluids. Correct product selection depends on the exact part and the installed vehicle brake system.

FAQ

What is the L04010?

It is a 1 L container of DOT 4 brake fluid from Brembo.

Does a vehicle name or similar-looking part confirm compatibility?

No. Match the exact part number and complete brake-system requirement, including all application notes.

Does this fluid fit every vehicle?

No. Confirm the vehicle manufacturer fluid type, grade, viscosity requirement and service procedure before use.

What container size is supplied?

This part number identifies a 1 L container.

Does a higher boiling point replace the specified fluid requirement?

No. The vehicle fluid specification and compatibility requirements determine selection.

Are additional service components automatically included?

Only the manufacturer package identified in this listing is supplied. Confirm all separately required service parts and any application-dependent accessories.

What should be checked before installation?

Compare the exact replacement with the vehicle requirement and supplied package, then follow the current manufacturer and vehicle service instructions.

Should this be installed using a generic online procedure?

Use the instructions for the exact product and vehicle. A qualified installer should resolve any mismatch before installation.

Installation Instructions

1. Confirm the exact part, application, package contents and required service equipment before work begins.
2. Follow the current Brembo and vehicle service instructions, including applicable system preparation and specified fasteners or fluid requirements.
3. Inspect installation, clearances, connections and system operation using the vehicle service procedure.
4. Complete any required bleeding, adjustment, bedding or warning-system checks before normal use.