Brake Pad Wear Indicator

Brembo A00483 is a brake-pad wear-indicator cable. Select the exact product for the installed brake system and verify all application requirements before ordering.

Key Features

• Manufacturer-listed cable length: 100 mm.
• Manufacturer axle reference: Front.
• Match the exact connector, cable routing and applicable installation side.
• Manufacturer part number: A00483.

Fitment

Before ordering A00483, confirm the exact brake configuration and every manufacturer application note. Existing vehicle references below are conditional and do not establish compatibility with every brake option.

Specifications

What’s Included

• Brembo A00483 wear-indicator component in the manufacturer package.

Brake pads, rotors, calipers and installation tools are separate.

About Brembo

Brembo manufactures braking components, service accessories and brake fluids. Correct product selection depends on the exact part and the installed vehicle brake system.

FAQ

What is the A00483?

It is a brake-pad wear-indicator cable from Brembo.

Does a vehicle name or similar-looking part confirm compatibility?

No. Match the exact part number and complete brake-system requirement, including all application notes.

Does this sensor replace worn brake pads?

No. It is a wear-indicator component. Worn pads and other service items must be selected separately.

Does cable length alone confirm compatibility?

No. Match the connector, applicable side and routing as well as the stated length and exact brake application.

Can a front/rear catalogue reference be treated as two sensors?

No. It describes possible positions on compatible applications, not the number of components supplied.

Are additional service components automatically included?

Only the manufacturer package identified in this listing is supplied. Confirm all separately required service parts and any application-dependent accessories.

What should be checked before installation?

Compare the exact replacement with the vehicle requirement and supplied package, then follow the current manufacturer and vehicle service instructions.

Should this be installed using a generic online procedure?

Use the instructions for the exact product and vehicle. A qualified installer should resolve any mismatch before installation.

Installation Instructions

1. Confirm the exact part, application, package contents and required service equipment before work begins.
2. Follow the current Brembo and vehicle service instructions, including applicable system preparation and specified fasteners or fluid requirements.
3. Inspect installation, clearances, connections and system operation using the vehicle service procedure.
4. Complete any required bleeding, adjustment, bedding or warning-system checks before normal use.