This universal Borla exhaust connecting pipe is selected by exact manufacturer part number 60744. Confirm every inlet, outlet, body, offset, clearance, finish, and fabrication requirement against the Borla drawing before ordering.

Key Features

• 4in centerline spacing on inlets and outlets.
• Determine the correct placement of the X-pipe in the custom exhaust build based on the 4in centerline spacing.
• Un-notched inlet and outlet necks designed for weld-in installation.
• Cut the existing exhaust piping to accept the un-notched inlet and outlet necks.
• Position the X-pipe for proper ground clearance, using the reversible design as needed for the specific installation.
• Weld the inlet and outlet necks to the adjoining exhaust piping.

Fitment

Specifications

What’s Included

One new Borla product identified by manufacturer part number 60744. Clamps, hangers, gaskets, tips, pipes, tools, and companion parts are included only when expressly listed for this exact part number.

About Borla

Borla develops stainless-steel exhaust systems, mufflers, tips, pipes, and related components for vehicle-specific and universal performance applications. Product selection remains exact-application and exact-part-number specific.

Related Borla Products

• Borla SwitchFire X-Pipe 2.5in Notched Universal Hydroformed
• Borla 15-19 Ford Mustang GT Convertible 5.0L AT/MT RWD 2DR 2.5IN X-Pipe & Mid-Pipes
• Borla Universal Resonator Option 2.75in Center/Center 5in Round x 10in

Browse the Borla collection for related exhaust systems and components.

Frequently Asked Questions

How do I confirm this universal Borla part will fit?
Match the inlet and outlet diameter, body dimensions, flow direction, offset or center layout, available clearance, material, finish, and required fabrication to the exact Borla drawing before ordering.

Will this change require an engine tune?
A cat-back, axle-back, tip, muffler, or post-catalyst component usually does not require tuning, but confirm the exact application, emissions configuration, oxygen-sensor locations, and local requirements before installation.

What should I inspect before installation?
Check the shipping carton and components against the exact part number, then inspect clamps, hangers, gaskets, mating flanges, clearances, tip alignment, and required reused factory hardware before removing the original exhaust.

Installation Instructions

Follow the current Borla instructions and vehicle service information for this exact part number. Let the exhaust cool, support the vehicle safely, compare all parts before removal, protect sensors and wiring, use the specified clamps and torque values, align all joints and tips without preload, confirm body and suspension clearance, check for leaks, and retorque after the first heat cycles. Professional installation is recommended.